B1242 Wireless Door Lock Tuner Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is output when the applicable RDA signal cannot be received within 1 second of PRG signal being output from the main body ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1242 |
In diagnostic mode, applicable RDA signal cannot be received within 1 second of PRG signal being output from main body ECU |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WIRE HARNESS (MAIN BODY ECU - DOOR CONTROL RECEIVER) |
![]() ![]() |
Disconnect the E20 ECU connector.
Disconnect the L10 receiver connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
E20-5 (RDA) - L10-2 (RDA)
Below 1 Ω
E20-6 (PRG) - L10-3 (PRG)
E20-5 (RDA) or L10-2 (RDA) - Body ground
10 kΩ or higher
E20-6 (PRG) or L10-3 (PRG) - Body ground
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND) |
![]() ![]() |
Disconnect the L10 receiver connector.
Measure the resistance and voltage of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
L10-1 (GND) - Body ground
Below 1 Ω
- Standard voltage:
Tester Connection
Specified Condition
L10-5 (+B) - Body ground
10 to 14 V
|
|
||||
| OK | |
| 3. REPLACE DOOR CONTROL RECEIVER |
Temporarily replace the door control receiver with a new or normally functioning one (Click here, Click here).
Perform the REGISTRATION procedures.
| NEXT | |
| 4. CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for DTC.
- OK:
- DTC B1242 is not output.
|
|
||||
| OK | ||
| ||


