REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2008 from Aug 2008
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT SEAT ASSEMBLY LH |
for Manual Seat:
Remove the front seat LH (Click here).
for Power Seat:
Remove the front seat LH (Click here).
| 3. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() ![]() |
Using a screwdriver, detach the 9 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 2 clips and remove the garnish.
| 4. REMOVE YAW RATE SENSOR BRACKET |
Remove the bolt and yaw rate sensor bracket.
| 5. REMOVE YAW RATE SENSOR ASSEMBLY (w/ VSC) |
Disconnect the yaw rate sensor connector.

Remove the 2 bolts and yaw rate sensor.
- NOTICE:
- Do not remove the sensor from the bracket.
| 6. REMOVE DECELERATION SENSOR (w/o VSC) |
Disconnect the deceleration sensor connector.

Remove the 2 bolts and deceleration sensor.
- NOTICE:
- Do not remove the sensor from the bracket.

