2005-2008 RAV4 · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. DRAIN DIFFERENTIAL OIL

  1. C109019
    Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.

  1. Install a new gasket to the rear differential drain plug.

  1. Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.


2. REMOVE TAILPIPE ASSEMBLY

HINT:
  1. 1AZ-FE: (Click here).
  2. 2AD-FTV: (Click here for CCO, Click here for DPF).
  3. 2AD-FHV: (Click here).
  4. 2AZ-FE: (Click here).


3. REMOVE CENTER EXHAUST PIPE ASSEMBLY

HINT:
  1. 1AZ-FE: (Click here).
  2. 2AZ-FE: (Click here).


4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

HINT:
  1. 2AD-FTV: (Click here for CCO, Click here for DPF).
  2. 2AD-FHV: (Click here).


5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

  1. C127524
    Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft.

    NOTICE:
    1. During the removal, do not exert excessive force on the universal joint.
    2. When removing, transporting or storing the propeller with center bearing shaft assembly, do not allow the No. 2 joint angle to exceed 20°.

  1. C127525E01
    Place matchmarks on the differential carrier and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft and differential carrier.

  1. C127526E01
    Place matchmarks on the transfer and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft from the transfer.


6. REMOVE DIFFERENTIAL CARRIER SUB-ASSEMBLY
  1. Disconnect the harness clamp.

  1. Remove the breather tube.

  1. C127575
    Disconnect the connector.

  1. C129479E01
    Support the rear differential carrier with a transmission jack or equivalent.

  1. Remove the bolt labeled A and bolt labeled B.

  1. C129480
    Slowly lower the jack and then tilt the rear differential carrier.

  1. C129481
    Set the tip of the tire lever to the position on the rear drive shaft inboard joint shown in the illustration. Then, using the ribbed part of the rear differential carrier as a fulcrum, disconnect the left and right rear drive shafts.

    NOTICE:
    Do not scratch the rear drive shaft dust cover.


7. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

  1. C109016E01
    Using SST, tap out the 2 oil seals.
    SST
    09308-00010  

← REMOVAL (Nov 2005 – Dec 2006)REMOVAL (from Aug 2007) →