2005-2008 RAV4 · Service Manual BODY

B2343 Position Initialization Incomplete

Diagnostic trouble codes · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008

DESCRIPTION

This DTC is output when the sliding roof drive gear (sliding roof ECU) has not been initialized.
DTC No.
DTC Detection Condition
Trouble Area
B2343
Sliding roof drive gear (sliding roof ECU) has not been initialized
  1. Sliding roof drive gear sub-assembly (sliding roof ECU)
  2. Overhead junction block (sliding roof control switch)
  3. Wire harness

WIRING DIAGRAM

Refer to DTC B2341 (Click here).

INSPECTION PROCEDURE


1. INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
  1. Check that the sliding roof drive gear can be initialized (Click here).

    OK:
    Sliding roof drive gear can be initialized.



NG
Go to step 3
OK


2. CHECK SLIDING ROOF FUNCTION
  1. Check the auto operation with the SLIDE OPEN and TILT UP switch (Click here).

    OK:
    Auto operation operates normally with SLIDE OPEN and TILT UP switch.



NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
OK

END

3. CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - OVERHEAD JUNCTION BLOCK)

  1. B130118E09
    Disconnect the R9 ECU connector.

  1. Disconnect the R8 junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R9-7 (DWN) - R8-9 (DOWN)
    Below 1 Ω
    R9-9 (UP) - R8-8 (UP)
    Below 1 Ω
    R8-7 (GND) - Body ground
    Below 1 Ω
    R8-9 (DOWN) - Body ground
    10 kΩ or higher
    R8-8 (UP) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. INSPECT OVERHEAD JUNCTION BLOCK (SLIDING ROOF CONTROL SWITCH)

  1. B141536E03
    Remove the overhead junction block.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    8 (UP) - 7 (GND)
    TILT UP switch pushed
    Below 1 Ω
    8 (UP) - 7 (GND)
    TILT UP switch not pushed
    10 kΩ or higher
    9 (DOWN) - 7 (GND)
    SLIDE OPEN switch pushed
    Below 1 Ω
    9 (DOWN) - 7 (GND)
    SLIDE OPEN switch not pushed
    10 kΩ or higher



NG
REPLACE OVERHEAD JUNCTION BLOCK (SLIDING ROOF CONTROL SWITCH)
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)


← B2342 Switch Failure (from Aug 2008)B2343 Position Initialization Incomplete (from Aug 2008) →