C1417 High Power Supply Voltage Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2008
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or alternator circuit, etc.
This DTC is canceled when the IG1 terminal voltage returns to normal.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1417 |
The IG1 terminal voltage is 17.4 V or higher for 1 second or more. |
|
WIRING DIAGRAM
Refer to DTC C1241 (Click here).INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK BATTERY |
Check the battery voltage.
- Standard voltage:
- 11 to 14 V
- Result:
Result
Proceed to
OK
A
NG
for 2AZ-FE
B
for 2GR-FE
C
|
|
||||
|
|
||||
| A | |
| 2. INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
Make sure that there is no looseness in the locking part and connecting part of the connectors.

Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A67-34 (IG1) - Body ground
Ignition switch ON
11 to 14 V
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
|
|
||||
| OK | ||
| ||
