2005-2008 RAV4 · Service Manual BRAKE

C1419 Acceleration Sensor Internal Circuit

Diagnostic trouble codes · Vehicles built from Aug 2008

Also covers:

DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
These DTCs are also output when calibration has not been completed.
DTC Code
DTC Detection Condition
Trouble Area
C1419
A data malfunction signal is received from the deceleration sensor.
Yaw rate and deceleration sensor
C1435
A data malfunction signal is received from the yaw rate sensor.
Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate sensor assembly, perform zero point calibration (Click here).

HINT:
When U0123, U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first (Click here).


1. REPLACE YAW RATE SENSOR ASSEMBLY
  1. Replace the yaw rate sensor assembly (Click here).

    NOTICE:
    Check the yaw rate and deceleration sensor signal after replacement (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).


NEXT

END


← C1417 High Power Supply Voltage Malfunction (from Aug 2008)C1420 Acceleration Sensor Malfunction (from Aug 2008) →