DTC C1422 Master Cylinder Pressure Sensor Zero Point High Malfunction |

| DTC Code | DTC Detection Condition | Trouble Area |
| C1422 | When the stop light switch is OFF, the PMC terminal voltage is more than 0.86 V for 5 seconds or more. |
|
| 1.CHECK STOP LIGHT OPERATION |
Check that the stop lights come on when the brake pedal is depressed, and go off when the brake pedal is released.
| Condition | Illumination Condition |
| Brake pedal depressed. | ON |
| Brake pedal released. | OFF |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
Check that the stop light condition observed on the intelligent tester changes according to brake pedal operation.
|
| ||||
| OK | |
| 3.CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION |
Turn the ignition switch off.
Check the brake pedal height and stop light switch installation (Click here).
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and perform braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC (C1422) is not output. | A |
| DTC (C1422) is output. | B |
|
| ||||
| A | ||
| ||
| 5.INSPECT SKID CONTROL ECU (STP2 TERMINAL) |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A67-22 (STP2) - Body ground | Stop light switch on (Brake pedal depressed) | 8 to 14 V |
| Stop light switch off (Brake pedal released) | Below 1.5 V |
|
| ||||
| OK | ||
| ||