TIRE PRESSURE WARNING SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
| Symbols (Terminals No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus '+' line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery ground | Always | 11 to 14 V |

| DIAGNOSIS SYSTEM |
![]() |
Warning light
The tire pressure warning light blinks when there is a malfunction in the tire pressure warning system.
DTCs (Normal mode)
DTCs are memorized in the tire pressure warning ECU and receiver. These DTCs can be read by checking the blinks of the tire pressure warning light or by using the intelligent tester (Click here).
Test mode
By switching from normal mode to test mode (input signal check), you can inspect the tire pressure monitor antenna, each tire pressure monitor valve and vehicle speed sensor (Click here).
| CHECK WARNING LIGHT |
![]() |
Turn the ignition switch on (IG).
Check that the tire pressure warning light turns on for 3 seconds.
If the warning check result is not normal, proceed to the troubleshooting for the tire pressure warning light circuit.
| Trouble Area | See page |
| Tire pressure warning light circuit |
Click here
|
| TIRE PRESSURE WARNING LIGHT CHART |
| Immediately after turning the ignition switch on (IG) | Always | ||||||
| Warning light output pattern | |||||||
| Turns on for 3 seconds | Turns off | Turns on | Flashes for 1 minute and then illuminates (*1) | Blinks (*2) | Blinks (*3) | Output DTC | |
| Normal | ○ | ○ | |||||
| Low tire pressure | ○ | ○ | |||||
| System fail | ○ | ○ | |||||
| Test mode | ○ | ○ | |||||
| ECU connector poorly connected | ○ | ○ | |||||
| TC ground (DTC is output) | ○ | ○ | |||||
| TC ground (DTC is not output) | ○ | ○ | |||||


