Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the tire pressure warning system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK INDICATOR LIGHT

      NEXT


      4.CHECK DTC*
      1. Check for DTC (Click here).

      2. Delete the DTC (Click here).

      3. Recheck for DTC (Click here).
        Result 
        Result
        Proceed to
        DTC reoccurs
        A
        DTC does not reoccur
        B



      B.
      Go to step 6
      A


      5.DTC CHART
      1. Check for tire pressure warning system DTC output (Click here).


      NEXT


      6.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        7.PROBLEM SYMPTOMS TABLE
          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        Go to step 9
        A


        8.OVERALL ANALYSIS AND TROUBLESHOOTING*
        1. Terminals of ECU (Click here).

        2. Data List / Active Test (Click here).


        NEXT


        9.REPAIR OR REPLACE

          NEXT


          10.CONFIRMATION TEST

            NEXT

            END