Home › DRIVE LINE › DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY

DIFFERENTIAL CARRIER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR DIFFERENTIAL SUPPORT


    C127579
  1. Install the differential support to the differential carrier with the 4 bolts.

    Torque:
    98 N*m{ 999 kgf*cm , 72 ft.*lbf }



2. INSTALL REAR DIFFERENTIAL NO. 1 AND NO. 2 SUPPORT


    C127578
  1. Install the differential No. 1 and No. 2 supports with the 4 bolts to the differential carrier.

    Torque:
    55 N*m{ 561 kgf*cm , 41 ft.*lbf }



3. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER
  1. Install the damper front side with the 2 bolts to the No. 1 support.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }



4. INSTALL DIFFERENTIAL CARRIER SUB-ASSEMBLY
  1. Support the rear differential carrier with a transmission jack or equivalent.

  1. Apply hypoid gear oil to the splines of the left and right rear drive shaft inboard joints.



    C129504
  1. Align the splines of the rear drive shaft inboard joints and, using a brass bar and hammer, tap in the left and right rear drive shafts.

    NOTICE:
    1. Face the cutout section of the snap ring downward.
    2. Do not damage the oil seal during the insertion.
    3. Do not strike the tip of the outboard joint with the hammer.

    HINT:
    Determine whether or not the rear drive shaft is completely tapped in by checking for changes in sound or the reaction force of the brass bar.



    C129479E01
  1. Slowly raise the transmission jack, install the 3 bolts.

    Torque:
    for bolt A:
    86 N*m{ 877 kgf*cm , 63 ft.*lbf }
    for bolt B:
    106 N*m{ 1080 kgf*cm , 78 ft.*lbf }

    NOTICE:
    Tighten the bolts, not the nuts.

  1. Connect the connector.



    C127575
  1. Install the breather tube.

  1. Connect the harness clamp.



5. INSTALL REAR SUSPENSION MEMBER BRACE LH
  1. Install the member brace with the 2 bolts to the suspension member.

    Torque:
    60 N*m{ 612 kgf*cm , 44 ft.*lbf }



6. INSTALL REAR SUSPENSION MEMBER BRACE RH

HINT:
Use the same procedures described for the LH side.



7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Install the propeller shaft assembly (Click here).



8. INSTALL EXHAUST PIPE ASSEMBLY
  1. Install the exhaust pipe for 2AD-FTV (Click here).

  1. Install the exhaust pipe for 2AD-FHV (Click here).



9. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank for 2AD-FTV (Click here).

  1. Install the fuel tank for 2AD-FHV (Click here).



10. ADD DIFFERENTIAL OIL
  1. Add the differential oil .