Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › DIFFERENTIAL OIL SEAL (for LH Side)

DIFFERENTIAL OIL SEAL (for LH Side) > REPLACEMENT

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 10 clips and engine under cover.



2. REMOVE REAR ENGINE UNDER COVER LH
  1. Remove the 2 clips and under cover.



3. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the refill plug and gasket from the automatic transaxle.



    C205876
  1. Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the automatic transaxle.



    C162883E04
  1. Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle and drain the automatic transaxle fluid.

  1. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the automatic transaxle.

    Torque:
    1.7 N*m{ 17 kgf*cm , 15 in.*lbf }

    Text in Illustration 
    *1
    No. 1 Transmission Oil Filler Tube
    *2
    Hexagon Socket Wrench
    *3
    Overflow Plug Hole

  1. Using a 6 mm socket hexagon wrench, install a new gasket and the overflow plug to the automatic transaxle.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

  1. Temporarily install the gasket and the refill plug to the automatic transaxle.



4. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
  1. Remove the front drive shaft (Click here).



5. REMOVE TRANSAXLE CASE OIL SEAL LH


C133598E04
  1. Using SST, tap out the transaxle case oil seal.

    SST
    09308-00010  



6. INSTALL TRANSAXLE CASE OIL SEAL LH


C188728E01
  1. Using SST and a hammer, tap in a new transaxle case oil seal.

    SST
    09316-10010  
    09950-70010   (09951-07100)

    Standard depth:
    -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

    NOTICE:
    Make sure that the oil seal is installed in the correct direction.

  1. Coat the lip of the transaxle case oil seal with MP grease.



7. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
  1. Install the front drive shaft (Click here).



8. ADD AUTOMATIC TRANSAXLE FLUID
  1. Add automatic transaxle fluid (Click here).



9. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK


10. INSTALL REAR ENGINE UNDER COVER LH
  1. Install the under cover with the 2 clips.



11. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 6 bolts and 10 clips.