DTC C1417 High Power Supply Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1417 | The IG1 terminal voltage is 17.4 V or higher for 1 second or more. |
|
| 1.CHECK BATTERY |
Check the battery voltage.
| Result | Proceed to | |
| OK | A | |
| NG | for 2AD-FHV | B |
| for 2AD-FTV | C | |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
![]() |
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A67-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||