Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS
If the skid control ECU detects a malfunction, the ABS and brake warning lights and the slip, VSC OFF, TRC OFF, downhill assist control and AUTO LSD indicator lights come on in accordance with the trouble area to warn the driver.

C203141E01

HINT:
  1. The DTCs can be read by connecting SST (09843-18040) between the TC and CG terminals of the DLC3 and observing the blinking pattern of the ABS and slip indicator lights, or by using the intelligent tester (Click here).
  2. This system has a sensor signal check function (Click here).


CHECK WARNING LIGHT AND INDICATOR LIGHT
  1. Release the parking brake lever.

    NOTICE:
    Before releasing the parking brake lever, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.



  2. When the ignition switch is turned to ON, check that the ABS and brake warning lights and the slip, VSC OFF, TRC OFF, downhill assist control and AUTO LSD indicator lights come on and go off in about 3 seconds.


    C203141E01

    HINT:
    If the warning lights do not illuminate, check for combination meter and CAN communication system DTCs, since the skid control ECU and combination meter are connected by the CAN communication line.
    If the warning light remains on, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.
    Section Title
    See Procedure
    ABS Warning Light Remains ON
    Click here
    VSC OFF Indicator Light Remains ON
    Click here
    Brake Warning Light Remains ON
    Click here
    Slip Indicator Light Remains ON
    Click here
    Downhill Assist Control Indicator Light Remains ON
    Click here
    AUTO LSD Indicator Light Remains ON
    Click here
    TRC OFF Indicator (Light) Remains ON
    Click here