VEHICLE STABILITY CONTROL SYSTEM > TRC OFF Indicator Light Remains ON |


| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL ECU CONNECTOR |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
| Result | Proceed to | |
| OK | A | |
| NG | for 1AZ-FE | B |
| for 2AZ-FE | C | |
| for 2GR-FE | D | |
| for 3ZR-FAE | E | |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING INTELLIGENT TESTER (AUTO LSD SWITCH) |
Check the Data List for proper functioning of the AUTO LSD switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Auto LSD Switch | Traction control switch (VSC OFF switch) / ON or OFF | ON: Traction control switch (VSC OFF switch) on OFF: Traction control switch (VSC OFF switch) off | - |
|
| ||||
| OK | |
| 5.INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
|
| ||||
| OK | ||
| ||
| 6.INSPECT TRACTION CONTROL SWITCH (VSC OFF SWITCH) |
![]() |
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (E) - 9 (+) | Switch is not pushed | 10 kΩ or higher |
| Switch is pushed | Below 1 Ω |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Disconnect the skid control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-30 (CSW) - E96-9 (+) | Always | Below 1 Ω |
| A67-30 (CSW) - Body ground | Always | 10 kΩ or higher |
| E96-6 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||