DTC P0420 Catalyst System Efficiency Below Threshold (Bank 1) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0420 | The Oxygen Storage Capacity (OSC) value is less than the standard value under active air fuel ratio control (2 trip detection logic). |
|

| *1 | Exhaust Manifold | *2 | Front Exhaust Pipe Assembly (TWC: Front Catalyst) |
| *3 | Center Exhaust Pipe Assembly (TWC: Rear Catalyst) | *4 | Tail Exhaust Pipe |



| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0420) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0420 is output | A |
| P0420 and other DTCs are output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (INJECTION VOLUME CONTROL) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Warm up the engine at an engine speed of 2500 rpm for approximately 90 seconds.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Injection Volume for A/F sensor.
Perform the Control the Injection Volume for A/F sensor operation with the engine idling (press the RIGHT or LEFT button to change the fuel injection volume).
Monitor the voltage outputs of the A/F and HO2 sensors (AFS Voltage B1 S1 and O2S B1 S2) displayed on the tester.
| Tester Display (Sensor) | Injection Volume | Status | Voltage |
| AFS Voltage B1 S1 (A/F) | +25% | Rich | Below 3.1 V |
| AFS Voltage B1 S1 (A/F) | -12.5% | Lean | Higher than 3.4 V |
| O2S B1 S2 (HO2) | +25% | Rich | Higher than 0.55 V |
| O2S B1 S2 (HO2) | -12.5% | Lean | Below 0.4 V |
| Status AFS Voltage B1 S1 | Status O2S B1 S2 | A/F Condition and A/F and HO2 Sensors Conditions | Misfires | Main Suspected Trouble Area | Proceed to |
| Lean/Rich | Lean/Rich | Normal | - |
| A |
| Lean | Lean/Rich | A/F sensor malfunction | - |
| B |
| Rich | Lean/Rich | A/F sensor malfunction | - |
| |
| Lean/Rich | Lean | HO2 sensor malfunction | - |
| C |
| Lean/Rich | Rich | HO2 sensor malfunction | - |
| |
| Lean | Lean | Actual air fuel ratio lean | May occur |
| D |
| Rich | Rich | Actual air fuel ratio rich | - |
|
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.INSPECT FOR EXHAUST GAS LEAK |
Inspect for exhaust gas leakage.
|
| ||||
| OK | |
| 4.REPLACE FRONT EXHAUST PIPE ASSEMBLY (TWC: FRONT CATALYST) |
Replace the front exhaust pipe assembly (Click here).
| NEXT | ||
| ||
| 5.INSPECT FOR EXHAUST GAS LEAK |
Inspect for exhaust gas leakage.
|
| ||||
| OK | ||
| ||