STEERING COLUMN ASSEMBLY (for RHD) > INSTALLATION |
| 1. INSTALL STEERING COLUMN ASSEMBLY |
![]() |
Install the steering column to the instrument panel reinforcement with the 3 bolts.
Connect all the connectors and attach all wire harness clamps to the steering column.
| 2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY |
Install the brake pedal support (Click here).
| 3. INSTALL NO.2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Align the matchmarks on the steering intermediate shaft and steering sliding yoke and temporarily install them with bolt B.
Align the matchmarks on the steering sliding yoke and steering gear assembly and install them with bolt A.
| 4. INSTALL AIR DUCT |
![]() |
| 5. INSTALL COLUMN HOLE COVER SILENCER SHEET |
![]() |
Install the column hole cover silencer sheet with the 2 clips.
Install the floor carpet.
| 6. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() |
Connect the connector.
Install the driver side knee airbag with the 4 bolts.
| 7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() |
Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
| 8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Driver Side Knee Airbag) |
![]() |
Attach the 3 claws to install the cover.
Install the 2 screws.
| 9. CONNECT POWER STEERING ECU |
![]() |
Connect the 2 steering column connectors to the power steering ECU.
Attach the clamps of the power steering motor harness.
Tilt the steering column up and down to make sure that the power steering motor wire harness and torque sensor wire harness do not interfere with any components.
| 10. INSTALL UPPER INSTRUMENT PANEL |
Install the instrument panel (Click here).
| 11. INSTALL COMBINATION SWITCH ASSEMBLY |
![]() |
Install the turn signal switch to the steering column with the clamp.
| 12. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() ![]() |
Install the spiral cable.
Connect the connectors to the spiral cable.
![]() |
Attach the 4 clips to the column cover (upper).
![]() |
Install the steering column cover (upper).
| 13. INSTALL STEERING COLUMN COVER |
![]() |
Attach the claw to install the steering column cover upper.
![]() |
Attach the 4 claws to install the steering column cover lower.
| 14. ADJUST SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| 15. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks and install the steering wheel to the steering column.
Install the nut.
Connect all the connectors to the spiral cable.
| 16. INSTALL STEERING PAD |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Attach the 2 spring to steering pad.
| 17. POSITION FRONT WHEELS FACING STRAIGHT AHEAD |
| 18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 19. INSPECT SRS WARNING LIGHT |
Inspect SRS warning light (Click here).