SFI SYSTEM > MIL Circuit |

| 1.CHECK THAT MIL IS ILLUMINATED |
Turn the ignition switch to ON.
Check the illumination condition of the MIL.
| Condition | Proceed to |
| MIL remains illuminated (Even after ignition switch turned to ON and several seconds have passed, MIL still remains illuminated) | A |
| MIL remains off (Does not illuminate at all) | B |
| MIL illuminates for several seconds, but turns off after engine is started | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK WHETHER MIL TURNS OFF |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check if any DTCs are output. Note down any DTCs.
Clear the DTCs (Click here).
Check if the MIL goes off.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that the MIL is not illuminated.
| *1 | Front view of wire harness connector (to ECM) |
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
![]() |
Disconnect the combination meter connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E22-8 (EFI) or A12-24 (W) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Combination Meter) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the combination meter connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||
| 5.CHECK THAT ENGINE STARTS |
Turn the ignition switch to ON.
Check that the engine starts.
| Result | Proceed to |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 6.CHECK COMBINATION METER ASSEMBLY |
![]() |
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-24 (W) - Body ground | Ignition switch ON | 11 to 14 V |
| *1 | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
![]() |
Disconnect the combination meter connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E22-8 (EFI) - A12-24 (W) | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Combination Meter) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the ECM connector.
Reconnect the combination meter connector.
|
| ||||
| OK | ||
| ||