DTC C1401 Front Speed Sensor RH Malfunction |
DTC C1402 Front Speed Sensor LH Malfunction |

| DTC Code | DTC Detection Condition | Trouble Area |
| C1401 C1402 | Any of the following is detected:
|
|

| 1.CHECK FRONT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.CHECK FRONT SPEED SENSOR TIP |
Remove the front speed sensor (Click here).
Check the speed sensor tip.
|
| ||||
| OK | |
| 3.CHECK FRONT SPEED SENSOR ROTOR |
Remove the front axle hub sub-assembly (Click here).
Check the speed sensor rotor.
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (FR/FL WHEEL SPEED) |
Install the front speed sensor and front axle hub sub-assembly.
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Wheel Speed | FR wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on the speedometer. |
| FL Wheel Speed | FL wheel speed sensor reading /min.: 0 km/h (0 mph), max.: 326.4 km/h (202.8 mph) | Actual wheel speed | Similar to speed indicated on the speedometer. |
Check that there is no difference between the speed value output from the speed sensor displayed on the intelligent tester and the speed value displayed on the speedometer when driving the vehicle.
|
| ||||
| OK | ||
| ||
| 5.REPLACE FRONT SPEED SENSOR |
Turn the ignition switch off.
Replace the front speed sensor (Click here).
| NEXT | |
| 6.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs (C1401 and C1402) are not output. | A |
| DTCs (C1401 and/or C1402) are output. | B |
|
| ||||
| A | ||
| ||