Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1201    Engine Control System Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction in the engine control system is detected, the operation of VSC and TRC is prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe control is canceled and the DTC is not stored.

DTC Code
DTC Detection Condition
Trouble Area
C1201
Engine control system malfunction signal continues for 1 second or more.
Engine control system

INSPECTION PROCEDURE

HINT:
Refer to the following pages when replacing the ECM.
  1. for 1AZ-FE: Click here.
  2. for 2AZ-FE: Click here.
  3. for 2GR-FE: Click here.
  4. for 3ZR-FAE: Click here.
Refer to the following pages when inspecting the engine control system (for DTC).
  1. for 1AZ-FE: Click here.
  2. for 2AZ-FE: Click here.
  3. for 2GR-FE: Click here.
  4. for 3ZR-FAE: Click here.

1.CHECK ENGINE CONTROL SYSTEM
  1. Check if any engine control system DTC is output.

    HINT:
    1. for 1AZ-FE: Click here.
    2. for 2AZ-FE: Click here.
    3. for 2GR-FE: Click here.
    4. for 3ZR-FAE: Click here.

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT ENGINE CONTROL SYSTEM (for DTC)
A

REPLACE ECM