Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1203    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The circuit is used to send TRC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU through the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
C1203
Engine, drive source and destination variations that are sent from the ECM do not match the ones of the skid control ECU.
ECM

INSPECTION PROCEDURE

1.CHECK PART NUMBER (SKID CONTROL ECU AND ECM)
  1. Check that the proper skid control ECU and ECM are installed.

    Result:
    Result
    Proceed to
    Proper ECUs are installed.
    for 1AZ-FE
    A
    for 2AZ-FE
    B
    for 2GR-FE
    C
    for 3ZR-FAE
    D
    Proper ECUs are not installed.
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECUS WITH PROPER ONES
A

REPLACE ECM (Click here)