NAVIGATION SYSTEM (for HDD) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.BASIC INSPECTION |
Turn the ignition switch to ACC.
Check whether or not the display appears on the navigation receiver assembly.
| Result | Proceed to |
| Display appears | A |
| Display does not appear | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the navigation system DTCs by simulating the conditions indicated by the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here).
Inspect the front No. 1 speaker (Click here).
Inspect the front No. 2 speaker (Click here).
Inspect the rear No. 1 speaker (Click here).
Inspect the steering pad switch (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|