IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. PERFORM IGNITION COIL AND SPARK TEST |
Check for DTCs (Click here).
Check whether sparks occur.
Remove the 4 ignition coils and 4 spark plugs (Click here).
![]() |
Disconnect the 4 injector connectors.
![]() |
Install the spark plug onto each ignition coil and connect the ignition coil connectors.
Ground the spark plug.
Check that sparks occur while the engine is being cranked.
Perform the spark test in accordance with the following procedure.
Check that the wire harness side connector of the ignition coil with igniter is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform a spark test on each ignition coil with igniter.
| Result | Proceed to |
| OK | Replace ignition coil with igniter |
| NG | Go to next step |
Check the spark plug.
| Result | Proceed to |
| NG | Replace spark plug |
| OK | Go to next step |
Check that power is supplied to the ignition coil with igniter.
| Result | Proceed to |
| NG | Check wiring between ignition switch and ignition coil with igniter |
| OK | Go to next step |
Check the camshaft position sensor (Click here).
Check the crankshaft position sensor (Click here).
Check the IGT signal circuit (Click here).
![]() |
Connect the 4 injector connectors.
Install the 4 ignition coils and 4 spark plugs (Click here).
| 2. INSPECT SPARK PLUG |
![]() |
Check the electrode.
Using a megohmmeter, measure the insulation resistance.
| *1 | Ground |
Alternative inspection method:
Quickly accelerate the engine to 4000 rpm 5 times.
Remove the spark plug.
![]() |
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its thread and insulator.
If there is any damage, replace the spark plug.
| Manufacturer | Product |
| DENSO | SC20HR11 |
Reference:
![]() |
Check the spark plug electrode gap.
Clean the spark plug.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry it.