BRAKE BOOSTER (for LHD) > REMOVAL |
| 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
Remove the windshield wiper motor and link assembly (Click here).
| 2. REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY |
![]() |
Disengage the 4 clips and remove the cowl ventilator housing sub-assembly.
| 3. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 14 bolts and cowl top panel outer sub-assembly.
| 4. REMOVE COWL BODY MOUNTING REINFORCEMENT LH |
![]() |
Remove the 2 nuts and cowl body mounting reinforcement LH.
| 5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE) |
Remove the air cleaner case (Click here).
| 6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE) |
Remove the air cleaner case (Click here).
| 7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 3ZR-FAE) |
Remove the air cleaner case (Click here).
| 8. DRAIN BRAKE FLUID |
| 9. DISCONNECT BRAKE LINE (w/o VSC) |
![]() |
Using a union nut wrench, disconnect the 6 brake lines from the actuator.
![]() |
Place tags or marks to identify the installation locations of each brake line.
| 10. DISCONNECT BRAKE LINE (w/ VSC) |
![]() |
Using a union nut wrench, disconnect the 6 brake lines from the actuator.
![]() |
Place tags or marks to identify the installation locations of each brake line.
| 11. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET (w/o VSC) |
![]() |
Release the latch of the actuator connector and disconnect the connector.
![]() |
Disconnect the brake tube clamp from the bracket.
![]() |
Remove the 3 nuts and actuator with bracket.
| 12. REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET (w/ VSC) |
![]() |
Disconnect the brake tube clamp from the bracket.
![]() |
Remove the 3 nuts and actuator with bracket.
| 13. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Release the vacuum pressure in the brake booster as follows.
Stop the engine.
Depress the brake pedal several times.
for Manual Transaxle:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 2 brake lines labeled C from the master cylinder.
Remove the 2 nuts.
![]() |
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
| 14. DISCONNECT VACUUM HOSE |
| 15. REMOVE PUSH ROD PIN |
Remove the clip from the push rod pin.
Remove the push rod pin from the push rod clevis.
| 16. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS |
Loosen the push rod clevis lock nut.
Remove the push rod clevis.
| 17. REMOVE BRAKE BOOSTER ASSEMBLY |
![]() |
Remove the 4 nuts.
Pull out the booster with gasket.
| 18. REMOVE BRAKE BOOSTER GASKET |
| 19. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY |
| 20. REMOVE CHECK VALVE GROMMET |