Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



RESULT LIST OF CHECK CAN BUS LINE (for LHD) 
Symptom
Suspected Area
See page
Open in CAN Main Wire
CAN Main Wire for Disconnection
Click here
Short in CAN Bus Line
CAN Bus Lines for Short Circuit
Click here
Short to +B in CAN Bus Line
CAN Bus Line for Short to +B
Click here
Short to GND in CAN Bus Line
CAN Bus Line for Short to GND
Click here
Open in One Side of CAN Branch Wire
Open in One Side of CAN Branch Wire
Click here

RESULT LIST OF CHECK CAN BUS LINE (for RHD) 
Symptom
Suspected Area
See page
Open in CAN Main Wire
CAN Main Wire for Disconnection
Click here
Short in CAN Bus Line
CAN Bus Lines for Short Circuit
Click here
Short to +B in CAN Bus Line
CAN Bus Line for Short to +B
Click here
Short to GND in CAN Bus Line
CAN Bus Line for Short to GND
Click here
Open in One Side of CAN Branch Wire
Open in One Side of CAN Branch Wire
Click here

COMMUNICATION STOP MODE TABLE 
Symptom
Suspected Area
See page
"ABS/VSC/TRC" not displayed on intelligent tester*1
Brake Actuator (Skid Control ECU) Communication Stop Mode
Click here
"ABS/VSC/TRC" not displayed on intelligent tester*2
ABS and Traction Actuator (Skid Control ECU) with Actuator Communication Stop Mode
Click here
"EPS" not displayed on intelligent tester
Power Steering ECU Communication Stop Mode
Click here
Steering Angle "Sensor" not displayed on intelligent tester*5
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate / Deceleration Sensor" not displayed on intelligent tester*2
Yaw Rate Sensor Communication Stop Mode
Click here
"Engine" not displayed on intelligent tester via CAN VIM
ECM Communication Stop Mode
Click here
"SRS Airbag" not displayed on intelligent tester
Airbag ECU Communication Stop Mode
Click here
"Air Conditioner" not displayed on intelligent tester
Air Conditioning Amplifier ECU Communication Stop Mode
Click here
"Combination Meter" not displayed on intelligent tester
Combination Meter ECU Communication Stop Mode
Click here
"Main Body" not displayed on intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Four Wheel Drive Control" not displayed on intelligent tester*3
4WD Control ECU Communication Stop Mode
Click here
"Entry & Start" not displayed on intelligent tester*4
Certification ECU Communication Stop Mode
Click here

MAIN BODY ECU DTC OUTPUT (CAN NO. 2 BUS LINE MALFUNCTION) 
Symptom
Suspected Area
See page
B1207
Certification ECU Communication Malfunction
Click here
B2326
CAN MS Bus Line Communication Malfunction
Click here
  1. *1: w/ Anti-lock Brake System
  2. *2: w/ Vehicle Stability Control System
  3. *3: for 4WD
  4. *4: w/ Entry and Start System
  5. *5: for 2WD (w/ Vehicle Stability Control System) and 4WD