Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE SENSOR ASSEMBLY (w/ VSC)


    C191844
  1. Install the yaw rate sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not damage the yaw rate sensor.
    2. Make sure that the yaw rate sensor is installed securely.

  1. Connect the yaw rate sensor connector.



2. INSTALL DECELERATION SENSOR (w/o VSC)


    C191841
  1. Install the deceleration sensor with the 2 bolts.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not damage the deceleration sensor.
    2. Make sure that the deceleration sensor is installed securely.

  1. Connect the deceleration sensor connector.



3. INSTALL YAW RATE SENSOR BRACKET


  1. Install the bracket with the bolt.


    C194672E01

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }



4. INSTALL FRONT DOOR SCUFF PLATE LH


    B129699
  1. Attach the 10 claws to install the scuff plate.



5. INSTALL FRONT SEAT ASSEMBLY LH
  1. for Manual Seat:
    Install the front seat LH (Click here).

  1. for Power Seat:
    Install the front seat LH (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR (w/ VSC)
  1. Perform the yaw rate and deceleration sensor zero point calibration (Click here).



8. INSPECT YAW RATE SENSOR SIGNAL (w/ VSC)
  1. Inspect the yaw rate sensor signal (Click here).



9. INSPECT DECELERATION SENSOR SIGNAL (w/o VSC)
  1. Inspect the deceleration sensor signal (Click here).