Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

ACTIVE TORQUE CONTROL 4WD SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Active torque control 4WD system 
Symptom
Suspected Area
See page
Phenomenon of tight-corner braking*
1. Steering angle sensor circuit
Click here
2. Linear solenoid circuit
Click here
3. 4WD control ECU
-
4WD indicator light remains on
4WD indicator light circuit
Click here
4WD indicator light does not come on
4WD indicator light circuit
Click here
The system is in the DTC output mode although terminals TC and CG of the DLC3 are not short circuited
1. TC and CG terminal circuit
Click here
2. 4WD indicator light circuit
-
The system is not in the DTC output mode although terminals TC and CG of the DLC3 are short circuited
1. TC and CG terminal circuit
Click here
2. 4WD indicator light circuit
-

HINT:
*:When driving in 4WD mode, the vehicle is hard to turn, as if the brakes were applied, due to the rotational difference between the front and rear tires while turning.