Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH
RM30B0U _59 Vehicle Exterior _009441 EXTERIOR PANELS / TRIM _0051140 BACK DOOR OUTSIDE GARNISH A

EXTERIOR PANELS / TRIM  BACK DOOR OUTSIDE GARNISH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


PROCEDURE

Hide 1.INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

Hide 2.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

a.

Attach the 4 clips to install the back door outside garnish sub-assembly.


b.

Connect the connector.


c.

Install the 4 nuts.


Hide 3.INSTALL REAR LIGHT ASSEMBLY LH

Hide 4.INSTALL REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 5.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)

Hide 6.INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)

HINT:

Use the same procedure described for the LH side.


Hide 7.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 8.INSTALL BACK DOOR SIDE GARNISH LH

Hide 9.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.


Hide 10.INSTALL BACK DOOR CENTER GARNISH