Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0061404 BACK DOOR OPENER SWITCH A

DOOR / HATCH  BACK DOOR OPENER SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS


PROCEDURE

Hide 1.INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

a.

Install the back door opener switch.

HINT:

Make sure the arrows on the back door opener switch and the back door garnish are pointing in the same direction.



Hide 2.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Hide 3.INSTALL REAR LIGHT ASSEMBLY LH

Hide 4.INSTALL REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 5.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)

Hide 6.INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)

HINT:

Use the same procedure as for the LH side.


Hide 7.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 8.INSTALL BACK DOOR SIDE GARNISH LH

Hide 9.INSTALL BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 10.INSTALL BACK DOOR CENTER GARNISH