This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch (warning cancel switch assembly) on, the blind spot monitor system may store this DTC by mistake.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AC2 | Slave Module Horizontal Axis Misalignment | When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated. | Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor main switch (warning cancel switch assembly) is on.
Check the installation condition of the blind spot monitor sensor RH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
Take the appropriate action in accordance with the result.
| Proceed to |
|---|
| NEXT |
NEXT
Install the rear bumper.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER>INSTALLATION
Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
| Proceed to |
|---|
| OK |
| NG |
OK
NG