Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051193 REAR AXLE HUB BOLT A

AXLE AND DIFFERENTIAL  REAR AXLE HUB BOLT  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

Hide 3.REMOVE REAR DISC

Hide 4.REMOVE REAR AXLE HUB BOLT LH

C229038
2.208,1.938 2.427,1.698 false 2.427,1.698 2.594,1.698 false 2.177,0.365 1.333,0.365 false 1.75,1.896 0.76,0.844 false 0.76,0.844 1.479,2.146 false 2.646,1.625 3.021,1.844 0.375,0.219 10 SST 0.979,0.292 1.354,0.51 0.375,0.219 10 SST 0.531,2.385 0.74,2.594 0.208,0.208 10 *a 2.823,2.458 3.031,2.667 0.208,0.208 10 *b 0.552,0.75 0.76,0.958 0.208,0.208 10 *1
*1 Nut
*a Hold
*b Turn


a.

Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.


b.

Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

SST
09611-12010  


Hide 5.INSTALL REAR AXLE HUB BOLT LH

C228495
2.552,0.833 2.802,0.354 false 2.802,0.354 3.021,0.354 false 2.313,0.719 1.917,0.229 false 1.917,0.229 1.635,0.229 false 1.188,1.906 0.646,2.469 false 0.646,2.469 1.313,2.219 false 1.177,2.854 1.417,3.063 0.24,0.208 10 *a 3.01,1.688 3.25,1.896 0.24,0.208 10 *b 1.438,0.146 1.677,0.354 0.24,0.208 10 *1 3.063,0.26 3.302,0.469 0.24,0.208 10 *2 0.438,2.396 0.677,2.604 0.24,0.208 10 *2
*1 Washer
*2 Nut
*a Hold
*b Turn


a.

Install a washer and nut to a new rear axle hub bolt as shown in the illustration.


b.

Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.


Hide 6.INSTALL REAR DISC

Hide 7.CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

Hide 8.INSPECT AND ADJUST PARKING BRAKE

Hide 9.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)