Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051194 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (for 2WD)

a.

Install the rear axle hub and bearing assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 2.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (for AWD)

a.

Align the shaft splines and drive shaft to the axle hub and bearing assembly.


b.

Install the axle hub and bearing to the rear axle carrier with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

NOTICE:

Be careful not to damage the drive shaft boot and speed sensor rotor.



Hide 3.INSTALL REAR AXLE SHAFT NUT LH (for AWD)

a.

Clean the threaded parts on the drive shaft and a new axle shaft nut using a non-residue solvent.

NOTICE:
·

Be sure to perform this work for a new drive shaft.

·

Keep the threaded parts free of oil and foreign objects.




b.

Using a 30 mm socket wrench, install a new axle shaft nut.

Torque:
216 N*m (2203 kgf*cm, 159 ft.*lbf)

HINT:

Stake the nut after inspecting for looseness and runout in the following steps.



Hide 4.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 6.CONNECT SKID CONTROL SENSOR WIRE (for 2WD)

a.

Connect the connector.


Hide 7.CONNECT REAR SPEED SENSOR LH (for AWD)

a.

Install the rear speed sensor to the rear axle carrier with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Do not twist the rear speed sensor when installing it.



Hide 8.INSTALL REAR DISC

Hide 9.CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

a.

Connect the rear disc brake caliper assembly with the 2 bolts.

Torque:
88 N*m (897 kgf*cm, 65 ft.*lbf)


Hide 10.STAKE REAR AXLE SHAFT NUT LH (for AWD)

C130588

a.

Using a chisel and hammer, stake the rear axle shaft nut.


Hide 11.INSPECT AND ADJUST PARKING BRAKE

Hide 12.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 13.INSPECT AND ADJUST REAR WHEEL ALIGNMENT