This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.
The certification ECU (smart key ECU assembly) controls the smart key system (for Entry Function) related items that are customizable via the display screen.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | Certification ECU (smart key ECU assembly) vehicle setting processing error. | ·
CAN communication system ·
Smart key system (for Entry Function) ·
Certification ECU (smart key ECU assembly) ·
Radio and display receiver assembly |
After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).
Use the Techstream to check if the CAN DTCs are not output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| No DTCs are output |
| CAN DTCs are output |
No DTCs are output
CAN DTCs are output
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the smart key system (for Entry Function) is malfunctioning.
Customization may not be possible depending on the malfunction in the smart key system (for Entry Function).
No malfunctions are present in the smart key system (for Entry Function).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Display the "Vehicle settings" screen.
Make a note of the customizable items for each certification ECU related system.
These items shown as customizable via the audio and visual system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.
Check the customize parameters list for the smart key system (for Entry Function) related items that can be customized via the display screen.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>CERTIFICATION ECU>REMOVAL
Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the display screen.
The items available for customization via the display screen can be customized successfully using the manual procedure.
| Proceed to |
|---|
| OK |
| NG |
OK
NG