The main body ECU (Multiplex Network Body ECU) receives headlight dimmer switch information signals and illuminates the high beam headlights.
Inspect the bulbs and fuses for circuits related to this system before performing the following inspection procedure.
Using the Techstream, perform the Active Test.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Head Light Hi | Headlight dimmer relay | ON or OFF | - |
| Tester Display |
|---|
| Head Light Hi |
| Proceed to |
|---|
| High beam headlights come on |
| High beam headlights do not come on |
High beam headlights come on
High beam headlights do not come on
Remove the running light relay from the No. 1 engine room relay block and junction block assembly.
Inspect the running light relay.
Click hereVehicle Exterior>LIGHTING (EXT)>RELAY>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Running Light Relay) |
Remove the running light relay from the No. 1 engine room relay block and junction block assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Running light relay terminal 6 (+B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Running light relay terminal 3 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the running light relay from the No. 1 engine room relay block and junction block assembly.
Disconnect the 3B instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Running light relay terminal 4 (H) - 3B-54 | Always | Below 1 Ω |
| 3B-54 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-22 (DIM) - 3B-54 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG