Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM
RM30B0U _59 Vehicle Exterior _010071 LIGHTING (EXT) _0054854 AUTOMATIC HIGH BEAM SYSTEM Y

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the automatic high beam system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the Techstream to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>PRECAUTION


Result:
Proceed to
CAN communication system DTCs are not output
CAN communication system DTCs are output



CAN communication system DTCs are not output

4.CHECK LANE DEPARTURE ALERT SYSTEM

CAN communication system DTCs are output

4.CHECK LANE DEPARTURE ALERT SYSTEM
a.

Use the Techstream to check if the lane departure alert system is functioning normally.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR


Result:
Proceed to
Lane departure alert system DTCs are not output
Lane departure alert system DTCs are output



Lane departure alert system DTCs are not output

5.CHECK FOR DTC*

Lane departure alert system DTCs are output

5.CHECK FOR DTC*
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Clear DTCs
50002 123

b.

Recheck for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>DTC CHECK / CLEAR

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Proceed to
DTCs are not output
DTCs are output



DTCs are not output

6.PROBLEM SYMPTOMS TABLE

DTCs are output

6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table



Fault is not listed in Problem Symptoms Table

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

Fault is listed in Problem Symptoms Table

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRM TEST
9.CONFIRM TEST
Result:
Proceed to
NEXT



NEXT

END