Wear protective gloves. Sharp areas on the parts may injure your hands.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY RH
Set the front seat cushion heater assembly RH on the separate type front seat cushion cover.
Using a tacker, install the front seat cushion heater assembly RH to the separate type front seat cushion cover with 20 new tack pins as shown in the illustration.
Do not substitute other metal parts for tack pins.
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
Set the separate type front seat cushion cover in place.
Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 21 new hog rings as shown in the illustration.
Be careful not to damage the separate type front seat cushion cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seat cushion cover.
Install the hog rings at the cutouts if they are there.
| *1 | Hog Ring Pliers | - | - |
| *a | Cutout | - | - |
3.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Attach the 11 hooks to install the separate type front seat cushion cover with pad.
4.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
5.INSTALL FRONT INNER SEAT CUSHION SHIELD RH
6.INSTALL FRONT SEAT CUSHION SHIELD RH
7.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
8.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION
9.INSPECT SEAT HEATER SYSTEM