Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM30B0U _55 Steering _010966 STEERING GEAR / LINKAGE _0058245 STEERING GEAR A

STEERING GEAR / LINKAGE  STEERING GEAR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STEERING GEAR ASSEMBLY

a.

Install the steering gear assembly to the front suspension crossmember with the 2 bolts and 2 nuts.

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)

NOTICE:
·

Make sure to tighten the bolts starting from the left side of the vehicle.

·

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut fixed in place.




Hide 2.INSTALL STEERING INTERMEDIATE SHAFT

a.
C275678
2.271,1.135 1.646,0.365 1.646,0.365 2.323,1.042 false 1.479,0.26 1.792,0.417 0.313,0.156 10 *a
*a Matchmark


Align the matchmarks and install the steering intermediate shaft to the steering gear assembly.


b.

Install the bolt.

Torque:
35.3 N*m (360 kgf*cm, 26 ft.*lbf)


Hide 3.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

a.

Align the round hole in the No. 1 steering column hole cover assembly with the protrusion of the steering gear assembly and install the cover.


b.

Install a new clamp.


Hide 4.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 5.INSTALL FRONT SUSPENSION MEMBER REAR BRACE LH

Hide 6.INSTALL FRONT SUSPENSION MEMBER REAR BRACE RH

HINT:

Use the same procedure described for the LH side.


Hide 7.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH

Hide 8.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

HINT:

Use the same procedure described for the LH side.


Hide 9.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

Hide 10.INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 11.CONNECT TIE ROD END SUB-ASSEMBLY LH

a.
C151407

Connect the tie rod end to the steering knuckle with the nut.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)

NOTICE:

Tighten the nut up to an additional 60° if the holes for the cotter pin are not aligned.



b.

Install a new cotter pin.


Hide 12.CONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 13.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY

a.

Align the matchmarks and install the No. 2 steering intermediate shaft assembly to the intermediate shaft.


b.

Install the bolt.

Torque:
35.3 N*m (360 kgf*cm, 26 ft.*lbf)


Hide 14.INSTALL COLUMN HOLE COVER SILENCER SHEET

Hide 19.INSTALL FRONT WHEELS

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 20.POSITION FRONT WHEELS FACING STRAIGHT AHEAD