Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY
RM30B0U _59 Vehicle Exterior _009875 DOOR / HATCH _0060877 FUEL LID LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  FUEL LID LOCK CONTROL CABLE ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 2.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 3.REMOVE DECK BOARD ASSEMBLY (for Compact Spare Tire)

Hide 4.REMOVE DECK BOARD ASSEMBLY (for Full Size Spare Tire)

Hide 6.REMOVE REAR FLOOR FINISH PLATE (for Compact Spare Tire)

Hide 7.REMOVE REAR DECK TRIM COVER (for Full Size Spare Tire)

Hide 8.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (for Compact Spare Tire)

Hide 9.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE (for Full Size Spare Tire)

Hide 10.REMOVE REAR SEAT ASSEMBLY

Hide 11.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 13.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 14.REMOVE REAR DOOR SCUFF PLATE LH

Hide 15.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 16.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 17.REMOVE OUTER LAP BELT ANCHOR COVER (for LH Side)

Hide 18.REMOVE LOWER CENTER PILLAR GARNISH LH

Hide 19.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

a.
B338190

Remove the bolt and detach the guide.


b.
B338191

Disconnect the fuel lid lock control cable sub-assembly and remove the fuel lid lock open lever sub-assembly.


Hide 20.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY

a.

Partially remove the floor carpet.

HINT:

It is not necessary to fully remove the floor carpet. Partially remove it so that the fuel lid lock control cable sub-assembly can be removed.



b.
B338141

Detach the 2 claws and disconnect the fuel lid lock control cable sub-assembly from the fuel filler opening lid lock retainer in the direction indicated by the arrow in the illustration.


c.

Detach the 7 clamps and remove the fuel lid lock control cable sub-assembly.

B338135


Hide 21.REMOVE FUEL FILLER OPENING LID LOCK RETAINER

a.
B338142

Turn the fuel filler opening lid lock retainer counterclockwise and remove the fuel filler opening lid lock retainer as shown in the illustration.