Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0054849 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1532  LVDS Signal Malfunction (from Extension Module)  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B1532 LVDS Signal Malfunction (from Extension Module) When either condition below is met:
·

The stereo component tuner assembly is not connected while the ignition switch is ON or ACC.

·

Communication between the radio and display receiver assembly and the stereo component tuner assembly is not possible when the engine is started.


·

No. 1 navigation wire

·

Stereo component tuner assembly

·

Radio and display receiver assembly



WIRING DIAGRAM

E280906
6.125,0.427 6.74,0.625 0.615,0.198 10 false US4- 5.74,0.427 6.208,0.677 0.469,0.25 10 false W7 5.802,0.198 6.271,0.448 0.469,0.25 10 false 2 6.135,0.865 6.75,1.063 0.615,0.198 10 false US4+ 5.74,0.865 6.208,1.115 0.469,0.25 10 false W7 5.802,0.656 6.271,0.906 0.469,0.25 10 false 3 5.74,1.313 6.208,1.563 0.469,0.25 10 false W7 6.135,1.292 6.75,1.49 0.615,0.198 10 false UGD4 5.802,1.094 6.271,1.344 0.469,0.25 10 false 4 6.135,1.74 6.75,1.938 0.615,0.198 10 false USV4 5.74,1.75 6.208,2 0.469,0.25 10 false W7 5.802,1.531 6.271,1.781 0.469,0.25 10 false 1 6.135,2.188 6.75,2.385 0.615,0.198 10 false USG4 5.74,2.188 6.208,2.438 0.469,0.25 10 false W7 5.823,1.979 6.292,2.229 0.469,0.25 10 false 5 3.313,2.333 3.927,2.531 0.615,0.198 10 false Shielded 0.719,0.417 1.333,0.615 0.615,0.198 10 false US4- 0.708,0.854 1.323,1.052 0.615,0.198 10 false US4+ 0.667,1.313 1.281,1.51 0.615,0.198 10 false UGD4 0.688,1.75 1.302,1.948 0.615,0.198 10 false USV4 0.677,2.177 1.292,2.375 0.615,0.198 10 false USG4 1.208,0.427 1.677,0.677 0.469,0.25 10 false W9 1.271,0.208 1.74,0.458 0.469,0.25 10 false 2 1.219,0.865 1.688,1.115 0.469,0.25 10 false W9 1.281,0.656 1.75,0.906 0.469,0.25 10 false 3 1.219,1.313 1.688,1.563 0.469,0.25 10 false W9 1.281,1.094 1.75,1.344 0.469,0.25 10 false 4 1.219,1.75 1.688,2 0.469,0.25 10 false W9 1.281,1.531 1.75,1.781 0.469,0.25 10 false 1 1.208,2.188 1.677,2.438 0.469,0.25 10 false W9 1.292,1.979 1.76,2.229 0.469,0.25 10 false 5 6.135,2.885 6.75,3.083 0.615,0.198 10 false +B2 5.729,2.896 6.198,3.146 0.469,0.25 10 false W4 5.813,2.667 6.281,2.917 0.469,0.25 10 false 4 6.135,3.302 6.75,3.5 0.615,0.198 10 false ACC2 6.135,3.76 6.75,3.958 0.615,0.198 10 false GND2 5.729,3.333 6.198,3.583 0.469,0.25 10 false W4 5.802,3.125 6.271,3.375 0.469,0.25 10 false 3 5.74,3.771 6.208,4.021 0.469,0.25 10 false W4 5.823,3.552 6.292,3.802 0.469,0.25 10 false 8 0.781,2.885 1.396,3.083 0.615,0.198 10 false +B2 0.677,3.333 1.292,3.531 0.615,0.198 10 false ACC2 0.667,3.771 1.281,3.969 0.615,0.198 10 false GND2 1.208,2.896 1.677,3.146 0.469,0.25 10 false W5 1.281,2.677 1.75,2.927 0.469,0.25 10 false 4 1.208,3.333 1.677,3.583 0.469,0.25 10 false W5 1.281,3.125 1.75,3.375 0.469,0.25 10 false 3 1.208,3.771 1.677,4.021 0.469,0.25 10 false W5 1.271,3.563 1.74,3.813 0.469,0.25 10 false 8 0.135,4.896 1.302,5.479 1.167,0.583 10 false Stereo Component Tuner Assembly 5.896,4.917 7.094,5.333 1.198,0.417 10 false Radio and Display Receiver Assembly 2.885,5.135 4.333,5.302 1.448,0.167 10 false No. 1 Navigation Wire 0.917,6.385 2.75,6.583 1.833,0.198 10 false : LVDS Communication Line 6.146,4.375 6.76,4.573 0.615,0.198 10 false LV1 0.813,4.406 1.427,4.604 0.615,0.198 10 false LV1

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

·

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DIAGNOSTIC TROUBLE CODE CHART

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DIAGNOSTIC TROUBLE CODE CHART

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
a.

Disconnect the W4 and W7 radio and display receiver assembly connectors.


b.

Disconnect the W5 and W9 stereo component tuner assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W7-1 (USV4) - W9-1 (USV4) Always Below 1 Ω
W7-2 (US4-) - W9-2 (US4-) Always Below 1 Ω
W7-3 (US4+) - W9-3 (US4+) Always Below 1 Ω
W7-4 (UGD4) - W9-4 (UGD4) Always Below 1 Ω
W7-5 (USG4) - W9-5 (USG4) Always Below 1 Ω
W4-4 (+B2) - W5-4 (+B2) Always Below 1 Ω
W4-3 (ACC2) - W5-3 (ACC2) Always Below 1 Ω
W4-8 (GND2) - W5-8 (GND2) Always Below 1 Ω
W7-1 (USV4) - Body ground Always 10 kΩ or higher
W7-2 (US4-) - Body ground Always 10 kΩ or higher
W7-3 (US4+) - Body ground Always 10 kΩ or higher
W7-4 (UGD4) - Body ground Always 10 kΩ or higher
W7-5 (USG4) - Body ground Always 10 kΩ or higher
W4-4 (+B2) - Body ground Always 10 kΩ or higher
W4-3 (ACC2) - Body ground Always 10 kΩ or higher
W4-8 (GND2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK NO. 1 NAVIGATION WIRE (LVDS COMMUNICATION LINE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK NO. 1 NAVIGATION WIRE (LVDS COMMUNICATION LINE)
a.

Replace the No. 1 navigation wire with a known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Check for DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (NO. 1 NAVIGATION WIRE [LVDS COMMUNICATION LINE] IS DEFECTIVE)

NG

4.CHECK STEREO COMPONENT TUNER ASSEMBLY
4.CHECK STEREO COMPONENT TUNER ASSEMBLY
a.

Replace the stereo component tuner assembly with a known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Check for DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (STEREO COMPONENT TUNER ASSEMBLY IS DEFECTIVE)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY