Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009009 NAVIGATION / MULTI INFO DISPLAY _0103736 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STEREO COMPONENT TUNER ASSEMBLY

Hide 2.INSTALL NO. 1 RADIO BRACKET

a.

Install the No. 1 radio bracket with the 5 screws.


Hide 3.INSTALL NO. 2 RADIO BRACKET

a.

Install the No. 2 radio bracket with the 5 screws.


Hide 5.INSTALL NAVIGATION RECEIVER ASSEMBLY

a.

Connect each connector.


b.

Attach the 4 clips to install the navigation receiver assembly with bracket.


c.

Install the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 6.INSTALL TELLTALE LIGHT ASSEMBLY

Hide 7.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 8.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 9.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION