When replacing the injectors (including shuffling the injectors between the cylinders), common rail, intake manifold or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe with a new one.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
26100
3.REMOVE DIESEL THROTTLE BODY ASSEMBLY
4.DISCONNECT ENGINE WIRE
25625
5.REMOVE EGR VALVE BRACKET
16295
6.REMOVE NO. 7 WATER BY-PASS HOSE
Slide the clamp and remove the No. 7 water by-pass hose from the electric EGR control valve assembly.
16296
7.DISCONNECT NO. 8 WATER BY-PASS HOSE
25602
8.REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY
25800
9.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
23804C
10.REMOVE FUEL INLET PIPE SUB-ASSEMBLY
23701
11.REMOVE INJECTION PIPE SUB-ASSEMBLY
23810A
12.REMOVE COMMON RAIL ASSEMBLY
17853B
13.REMOVE INTAKE MANIFOLD INSULATOR
Remove the intake manifold insulator from the intake manifold.
11452
14.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the engine oil level dipstick.
Disconnect the connector and detach the wire harness clamp from the engine oil level dipstick guide.
Remove the 2 bolts and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
89421C
15.REMOVE DIESEL TURBO PRESSURE SENSOR
23265
16.REMOVE NO. 1 GAS FILTER
Disconnect the vacuum hose.
Remove the No. 1 gas filter from the gas filter bracket.
17696
17.REMOVE GAS FILTER BRACKET
Remove the 2 bolts and gas filter bracket.
12631A
18.REMOVE ENGINE COVER BRACKET
Remove the bolt and engine cover bracket.
17112
19.REMOVE NO. 2 INTAKE MANIFOLD
Remove the bolt, 2 nuts, No. 2 intake manifold and gasket.
25770A
20.DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
Slide the clamp and disconnect the No. 2 vacuum transmitting hose assembly from the intake manifold.
17111
21.REMOVE INTAKE MANIFOLD
| *1 | Nut |
Remove the 7 bolts, 2 nuts, intake manifold and gasket.
22.REMOVE STUD BOLT
If a stud bolt is deformed or the threads are damaged, replace it.