1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
51444C
5.REMOVE REAR ENGINE UNDER COVER LH
74404A
6.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28800
7.REMOVE BATTERY
74431
8.REMOVE BATTERY TRAY
16057
9.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY
74411B
10.REMOVE FRONT BATTERY BRACKET
74414B
11.REMOVE BATTERY BRACKET REINFORCEMENT
12.DRAIN ENGINE COOLANT
32930A
13.REMOVE TRANSMISSION OIL COOLER HOSE ASSEMBLY
| *1 | Oil Cooler Inlet Hose |
| *2 | Oil Cooler Outlet Hose |
| *3 | Oil Cooler |
| *4 | Transmission Oil Cooler Hose |
| *5 | Oil Cooler Tube |
Slide the 4 clips and disconnect the 2 oil cooler inlet hoses and 2 oil cooler outlet hoses from the transaxle and oil cooler.
Slide the 2 clips and disconnect the 2 transmission oil cooler hoses from the oil cooler tube.
| *1 | Oil Cooler Inlet Tube |
| *2 | Oil Cooler Outlet Tube |
Slide the 4 clips and disconnect the 2 oil cooler inlet hoses and 2 oil cooler outlet hoses from the oil cooler inlet tube and oil cooler outlet tube.
Slide the 2 clips and disconnect the oil cooler inlet tube and oil cooler outlet tube from the transmission oil cooler hose assembly.
32907F
14.REMOVE OIL COOLER TUBE SUB-ASSEMBLY
Slide the 4 clips and disconnect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose from the radiator and oil cooler tube.
Remove the 2 bolts and oil cooler tube aqssembly from the radiator assembly.
33493B
15.REMOVE OIL COOLER
Slide the 2 clips and disconnect the 2 water by-pass hoses from the oil cooler.
Remove the 3 bolts and oil cooler from the continuously variable transaxle assembly.