11212
1.REMOVE NO. 2 CYLINDER HEAD COVER
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
17705
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
6.REMOVE AIR CLEANER FILTER ELEMENT
7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
74404A
8.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28800
9.REMOVE BATTERY
74431
10.REMOVE BATTERY TRAY
74411B
11.REMOVE FRONT BATTERY BRACKET
74414B
12.REMOVE BATTERY BRACKET REINFORCEMENT
89413B
13.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)
Disconnect the transmission revolution sensor connector.
Remove the bolt and transmission revolution sensor (NT).
Remove the O-ring from the transmission revolution sensor (NT).
89413B
14.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)
Disconnect the transmission revolution sensor connector.
Remove the bolt and transmission revolution sensor (NIN).
Remove the O-ring from the transmission revolution sensor (NIN).
89413B
15.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)
Disconnect the transmission revolution sensor connector.
Remove the bolt and transmission revolution sensor (NOUT).
Remove the O-ring from the transmission revolution sensor (NOUT).
Lower the vehicle.