Home › Drivetrain › K111 MULTIDRIVE / CVT › TRANSMISSION CONTROL CABLE
RM3090E _52 Drivetrain _008435 K111 MULTIDRIVE / CVT _0047077 TRANSMISSION CONTROL CABLE A

K111 MULTIDRIVE / CVT  TRANSMISSION CONTROL CABLE  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 51441 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 17705 6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 7.REMOVE AIR CLEANER FILTER ELEMENT

Hide 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 74404A 9.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28800 10.REMOVE BATTERY

Hide 74431 11.REMOVE BATTERY TRAY

Hide 74411B 12.REMOVE FRONT BATTERY BRACKET

Hide 74414B 13.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 58810J 14.REMOVE CONSOLE BOX ASSEMBLY

Hide 15.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C203403

Disconnect the end of the transmission control cable assembly from the shift lever.


c.
C127813C03
2.168,0.068 2.379,0.274 0.211,0.206 10 *1 0.945,0.221 1.156,0.426 0.211,0.206 10 *2 1.809,0.669 2.059,0.162 2.059,0.162 2.157,0.162 false 1.49,0.808 1.24,0.301 1.24,0.301 1.142,0.301 false
*1 Stopper
*2 Nut


Pull out the stopper of the transmission control cable assembly.


d.

Rotate the nut of the transmission control cable counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever retainer.

NOTICE:

Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.



e.
C279770

Remove the nut and disconnect the control cable assembly from the control shaft lever.


f.

Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.


g.
C201443

Disconnect the transmission control cable assembly from the control cable support.


h.
C201440

Remove the bolt and disconnect the clamp of the transmission control cable assembly.


i.
C127837

Remove the 2 nuts and disconnect the transmission control cable assembly.


j.

Pull out the transmission control cable assembly to remove it.