Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM3090E _55 Steering _008772 POWER ASSIST SYSTEMS _0049011 POWER STEERING SYSTEM G

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK STEERING EFFORT (TORQUE)

a.

Stop the vehicle on a level, paved surface and align the wheels straight ahead.



c.

Connect the cable to the negative (-) battery terminal.


d.

Using a torque wrench, check that the steering wheel set nut is properly tightened.

Click hereSteering>STEERING COLUMN>STEERING WHEEL>INSTALLATION


e.

Start the engine so that the power steering is ready to operate.


f.

Turn the steering wheel 90 degrees to the right and check the steering effort (torque) while continuing to turn it further in the same direction.

Standard steering effort (Reference):

6.0 N*m (61 kgf*cm, 53 in.*lbf) or less



g.

Align the front wheels facing straight ahead.


h.

Turn the ignition switch off.


i.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.