Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0049572 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.



NOTICE:

Do not remove the steering angle sensor from the spiral cable.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45286 5.REMOVE STEERING COLUMN COVER

Hide 84306 6.REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

a.

Remove the spiral cable with steering angle sensor.



NOTICE:
·

Do not replace spiral cable with steering angle sensor with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with steering angle sensor with the battery connected and the ignition switch ON.

·

w/ Vehicle Stability Control System:

Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

·

Do not remove the steering angle sensor from the spiral cable.