Home › Engine / Hybrid System › 3ZR-FAE STARTING › STARTER › 2012.12–2016.08
RM3090E _51 Engine / Hybrid System _008393 3ZR-FAE STARTING _0049596 STARTER A

3ZR-FAE STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 11212 5.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 17705 6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 74404A 7.REMOVE BATTERY CLAMP SUB-ASSEMBLY

a.
A296336

Remove the bolt and loosen the nut.


b.

Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.


Hide 28800 8.REMOVE BATTERY

Hide 74431 9.REMOVE BATTERY TRAY

Hide 16057 10.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY

a.
A296337

Remove the 2 bolts and disconnect the radiator hose sub-assembly from the front battery bracket.


Hide 74417 11.REMOVE FRONT BATTERY BRACKET

a.
A300697

Detach the 3 wire harness clamps.


b.
A296338

Remove the 4 bolts and front battery bracket.


Hide 74414B 12.REMOVE BATTERY BRACKET REINFORCEMENT

a.
A296339

Remove the 2 bolts and battery bracket reinforcement.


Hide 33820B 13.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for CVT)

a.
A296340

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 33823 14.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for CVT)

Hide 28100 15.REMOVE STARTER ASSEMBLY

a.
A211434

Disconnect the terminal cap.


b.

Remove the nut and disconnect the starter wire.


c.

Disconnect the starter connector.


d.

Remove the 2 bolts and starter assembly.


Hide 11363A 16.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A207285

Remove the flywheel housing side cover from the cylinder block.