1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
51441
5.REMOVE NO. 1 ENGINE UNDER COVER
6.DRAIN ENGINE COOLANT
52119A
7.REMOVE FRONT BUMPER COVER
8.REMOVE HEADLIGHT ASSEMBLY
for Halogen Headlight
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>REMOVAL
for HID Headlight
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for HID Headlight)>REMOVAL
52618
9.REMOVE FRONT LOWER BUMPER ABSORBER
Remove the 4 screws and front lower bumper absorber.
12611
10.REMOVE NO. 1 ENGINE COVER
74404A
11.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28899
12.REMOVE BATTERY INSULATOR
28800
13.REMOVE BATTERY
74431
14.REMOVE BATTERY TRAY
74411B
15.REMOVE FRONT BATTERY BRACKET
74414B
16.REMOVE BATTERY BRACKET REINFORCEMENT
86520
17.REMOVE LOW PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>REMOVAL
86510
18.REMOVE HIGH PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>REMOVAL
52085
19.REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY
Remove the 2 bolts, clip and front bumper center stay sub-assembly.
52029
20.REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
Remove the 2 bolts and front bumper upper reinforcement sub-assembly.
16681A
21.REMOVE UPPER RADIATOR AIR GUIDE PLATE
Remove the 6 clips and upper radiator air guide plate.
16683A
22.REMOVE LOWER RADIATOR AIR GUIDE PLATE
Detach 3 claws and remove the lower radiatorair guide plate.
88625P
23.DISCONNECT AMBIENT THERMISTOR ASSEMBLY
Detach the clamp to disconnect the ambient thermistor assembly.
52131A
24.REMOVE FRONT BUMPER REINFORCEMENT
88703
25.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.
Remove the O-ring from the discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88706
26.DISCONNECT LIQUID TUBE SUB-ASSEMBLY
Remove the bolt and disconnect the liquid tube sub-assembly from the cooler condenser assembly.
Remove the O-ring from the liquid tube sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
16691A
27.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH
Detach 3 claws and remove the front radiator side air guide plate RH.
16693A
28.REMOVE REAR RADIATOR SIDE AIR GUIDE PLATE RH
Remove the 2 clips and rear radiator side air guide plate RH.
16695A
29.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH
Detach 3 claws and remove the front radiator side air guide plate LH.
16697A
30.REMOVE REAR RADIATOR SIDE AIR GUIDE PLATE LH
Remove the 2 clips and rear radiator side air guide plate LH.
25770A
31.DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
Slide the clip and disconnect the No. 2 vacuum transmitting hose assembly from the intake manifold.
16533B
32.REMOVE NO. 1 RADIATOR SUPPORT
Remove the 2 bolts and 2 No. 1 radiator supports.
Remove the 2 radiator support cushions.
16261G
33.REMOVE NO. 1 WATER BY-PASS HOSE
Slide the 2 clamps and disconnect the No. 1 water by-pass hose from the radiator reservoir assembly and radiator hose sub-assembly.
Detach the hose clamp from the upper radiator support.
Remove the 2 bolts and disconnect the water by-pass hose clamp bracket from the upper radiator support.
34.DISCONNECT WIRE HARNESS
Disconnect the 4 connector and detach the 13 clamps.
53510
35.REMOVE HOOD LOCK ASSEMBLY
53216A
36.REMOVE UPPER RADIATOR SUPPORT
Remove the 4 bolts and upper radiator support.
16057
37.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY
16572D
38.DISCONNECT NO. 2 RADIATOR HOSE
17342F
39.REMOVE INTERCOOLER AIR HOSE
Loosen the 2 hose clamps.
Remove the intercooler air hose from the No. 1 air tube and intercooler assembly.
17343D
40.REMOVE NO. 3 AIR HOSE
16400
41.REMOVE RADIATOR ASSEMBLY
Remove the radiator assembly and 2 cushions.
16533
42.REMOVE NO. 2 RADIATOR SUPPORT
Remove the 4 bolts and 2 No. 2 radiator supports.
88460
43.REMOVE COOLER CONDENSER ASSEMBLY
Remove the cooler condenser assembly.
25770A
44.REMOVE NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
Detach the 4 clamps from the fan shroud and No. 2 air tube.
Slide the 2 clips and remove the No. 2 vacuum transmitting hose assembly from the intercooler assembly and No. 2 air tube.
17362B
45.REMOVE NO. 2 AIR TUBE
Loosen the hose clamp.
Remove the bolt and No. 2 air tube from the intercooler assembly.
16057
46.REMOVE RADIATOR HOSE SUB-ASSEMBLY
Disconnect the 2 clamps from the fan shroud.
Slide the 2 clamps and remove the radiator hose sub-assembly from the radiator assembly.
16572D
47.REMOVE NO. 2 RADIATOR HOSE
Slide the clamp and remove the No. 2 radiator hose from the radiator assembly.
16535
48.REMOVE LOWER RADIATOR SUPPORT
17940D
49.REMOVE INTERCOOLER ASSEMBLY
16711
50.REMOVE FAN SHROUD
Remove the 3 bolts and fan shroud.