Home › Drivetrain › EB61 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE ASSEMBLY
RM3090E _52 Drivetrain _008757 EB61 MANUAL TRANSMISSION / TRANSAXLE _0050275 MANUAL TRANSAXLE ASSEMBLY A

EB61 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.


PROCEDURE

Hide 1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

Hide 28100 2.REMOVE STARTER ASSEMBLY

Hide 30300 3.REMOVE MANUAL TRANSAXLE ASSEMBLY

a.
C277966

Remove the bolt and clamp.


b.

Disconnect the back-up light switch connector and remove the bolt and engine wire from the manual transaxle assembly.


c.
C206809

Remove the 8 bolts and manual transaxle assembly.


Hide 12311A 4.REMOVE FRONT ENGINE MOUNTING BRACKET

a.
C197778

Remove the 4 bolts and front engine mounting bracket.


Hide 12325A 5.REMOVE ENGINE MOUNTING BRACKET LH

a.
C200440

Remove the 4 bolts and engine mounting bracket LH.


Hide 12321A 6.REMOVE REAR ENGINE MOUNTING BRACKET

a.
C277911

Remove the 4 bolts and rear engine mounting bracket.


Hide 31490 7.REMOVE CLUTCH ACCUMULATOR ASSEMBLY

Hide 31407B 8.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

Hide 31400 9.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

Hide 33403K 10.REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY

a.
C206813

Remove the bolt and speedometer driven hole cover sub-assembly from the manual transaxle case.


b.

Remove the O-ring from the speedometer driven hole cover sub-assembly.