If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the brake actuator assembly (skid control ECU) is detected while the cruise control is in operation, the ECM determines there to be a momentary interruption or noise, and stores a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0503 | Vehicle Speed Sensor "A" Intermittent / Erratic / High | A malfunction in the vehicle speed signal is detected while the cruise control is in operation. | ·
Vehicle stability control system ·
Vehicle speed sensor ·
Vehicle speed sensor signal circuit ·
Combination meter assembly ·
ECM |
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| Vehicle stability control system DTCs are not output |
| Vehicle stability control system DTCs are output |
Vehicle stability control system DTCs are not output
Vehicle stability control system DTCs are output
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control switch on.
Push the cruise control switch to -SET to activate the cruise control.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC P0503 is not output |
| DTC P0503 is output |
DTC P0503 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC P0503 is output
for 1AD-FTV: Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2AD-FHV: Click hereEngine / Hybrid System>2AD-FHV ENGINE CONTROL>ECM>REMOVAL
for 2AD-CCo, 2AD-DPF: Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2AR-FE: Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>ECM>REMOVAL
for 3ZR-FAE: Click hereEngine / Hybrid System>3ZR-FAE ENGINE CONTROL>ECM>REMOVAL
for 3ZR-FE: Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>ECM>REMOVAL