When the ECM detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control SET indicator light turns on.
The cruise control SET indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
Select the Active Test, use the GTS to generate a control command, and then check that the cruise control SET indicator light illuminates.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. SET | Cruise control SET indicator light | ON or OFF | - |
| Tester Display |
|---|
| Indicat. SET |
| Proceed to |
|---|
| Cruise control SET indicator light turns ON/OFF |
| Cruise control SET indicator light does not turn ON/OFF |
Cruise control SET indicator light turns ON/OFF
Cruise control SET indicator light does not turn ON/OFF
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check the Data List for proper functioning of the cruise control SET indicator light.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| SET/COAST Switch | -SET switch | ON or OFF | ON: -SET switch on
OFF: -SET switch off |
- |
| Tester Display |
|---|
| SET/COAST Switch |
On screen, item changes between ON and OFF according to above chart.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for 1AD-FTV: Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2AD-FHV: Click hereEngine / Hybrid System>2AD-FHV ENGINE CONTROL>ECM>REMOVAL
for 2AD-CCo, 2AD-DPF: Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECM>REMOVAL
for 2AR-FE: Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>ECM>REMOVAL
for 3ZR-FAE: Click hereEngine / Hybrid System>3ZR-FAE ENGINE CONTROL>ECM>REMOVAL
for 3ZR-FE: Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>ECM>REMOVAL